 EZI-ACTION
SHALLOW WELL PUMP
When it comes to taking water from Shallow
Wells up to (80ft) 25 metres deep to the water, the EZI-action Shallow
Well Pump has many benefits.
- in a Kitset form it is easy to install (up to 20 minutes).
- kitset comes with pipe connection to the water.
- pipe sections are connected by threaded joints that are only hand
tightened.
- made from uPVC there is nothing to rust or corrode.
- low cost pump that has been thoroughly tested.
(Special Introductory Price).
Easy to install Kitset package
The pump is made from PVC plastic which makes it light to handle. Each
section is threaded for easy assembly. 2 people will take between 15 and
20 minutes to install a 52ft pump. No additional piping or
plumbing required.
20 to 35 litres per minute (5 to 8 Gallons)
You will pump between 5 and 8 gallons per minute depending on the depth
of the pump and speed of operation. Water is delivered on both the up
and down stroke. An ergonomical pumping action using the legs is shown
in the installation instructions. (Some say it is better exercise than
going to the gym).
Tested to 10 million cycles
During research a shallow well pump with this patented pumping principle
was continuously run for 10 million pumping cycles. At the end of the
test the pump was delivering the same amount of water per cycle as at
the beginning, and when dis-assembled little or no wear could be
detected.
Patented pumping action
The unique factor about this pump is that it is neither a piston nor a
vacuum pump. It incorporates a unique pumping principle that does not
have to overcome any friction in the pumping action.
|
